Thursday, July 30, 2020

Yamaha ERG121C Makeover: Part Two

Quick Links: Part One | Part Two | Part Three

In Part One of this series, I'd put down about a half dozen coats of Tru-Oil; and this included a light scuffing with 0000 steel wool every 3 coats or so. Well, after 20 coats of Tru-Oil, I lost count and just concentrated on achieving the desired finish thickness. After the final coat, the body was set aside for a week to allow the finish to cure. Then it was time to take care of the conductive paint shielding and grounding tabs.

Following this, the pickups and electronics were installed. Now, since a complete rewire was on the cards, I decided to do a minor upgrade and put in a Russian K73-16 0.022uF tone cap, Gavitt cloth-covered pushback wire for short runs; and Gavitt single-conductor braided shield wire from the volume pot to the output jack. I felt that it was only fitting as the owner had already spent his hard-earned money on bona fide Seymour Duncan pickups, CTS 500K pots, CRL 5-way switch; and Switchcraft #11 jack.

As I type this the rewiring's been completed, tested; and everything checks out okay. What's left is to reattach the neck, string her up with 10s; and do a complete setup. Do stay tuned for updates on this Yamaha ERG121C. Till we meet again in cyberspace, stay home, stay safe; and avoid crowded spaces.













No comments:

Post a Comment

Thank you for dropping by. All comments are highly appreciated.