This is the third instalment of an ongoing series concerning a makeover on a custom Explorer-style five-string bass. I'd finally determined what I thought was the correct bridge location in terms of scale length/intonation and side-to-side string alignment. However, I was wrong. The correct location was still at the same distance from the nut, but slightly to the right of the body's center line.
After six new holes had been drilled for the bridge mounting screws, the bridge was successfully installed. The neck was then reattached, and the bass strung with "dummy" G and B strings. I'm glad to report that side-to-side string alignment was where I wanted it to be. That being taken care of, it was time to remove the masking tape, clean off any tape glue residue; and plug redundant screw holes. These holes were plugged with wood glue-laced wooden dowels, which, once the glue had cured; were trimmed and sanded flush with the surrounding wood.
While all this was going on, I suddenly realized that neck mounting screws were quite loose; even when fully tightened. Further investigation revealed that one of these screws was slightly shorter and smaller in diameter than the others, the screw heads were chewed up and rusty; plus the existing holes in the neck heel were worn out. The obvious solution was to: (i) plug the screw holes and redrill, and (ii) replace the neck mounting screws with a matching set.
The neck heel hole-plugging process was similar to that employed for the redundant screw holes in the body; except that larger wood dowels were used. Once this was done, the neck was reattached; and everything now fit "as snug as a bug in a rug" (as my late Dad would say).
That's all I have to share for this post. The next stage of this makeover should be grain-filling, staining; and refinishing the body. Thanks for dropping by. Stay safe, wear a mask when outdoors; and I'll see you all real soon :)
After six new holes had been drilled for the bridge mounting screws, the bridge was successfully installed. The neck was then reattached, and the bass strung with "dummy" G and B strings. I'm glad to report that side-to-side string alignment was where I wanted it to be. That being taken care of, it was time to remove the masking tape, clean off any tape glue residue; and plug redundant screw holes. These holes were plugged with wood glue-laced wooden dowels, which, once the glue had cured; were trimmed and sanded flush with the surrounding wood.
While all this was going on, I suddenly realized that neck mounting screws were quite loose; even when fully tightened. Further investigation revealed that one of these screws was slightly shorter and smaller in diameter than the others, the screw heads were chewed up and rusty; plus the existing holes in the neck heel were worn out. The obvious solution was to: (i) plug the screw holes and redrill, and (ii) replace the neck mounting screws with a matching set.
The neck heel hole-plugging process was similar to that employed for the redundant screw holes in the body; except that larger wood dowels were used. Once this was done, the neck was reattached; and everything now fit "as snug as a bug in a rug" (as my late Dad would say).
That's all I have to share for this post. The next stage of this makeover should be grain-filling, staining; and refinishing the body. Thanks for dropping by. Stay safe, wear a mask when outdoors; and I'll see you all real soon :)
 |
 |
 |
|---|---|---|
 |
 |
 |
 |
 |
 |
 |
 |
 |
No comments:
Post a Comment
Thank you for dropping by. All comments are highly appreciated.